This method is used when the blind is being
attached to a flat surface behind the blind such
as window frame or wall. Use two screws
when using this method.

This method is used when fitting to a surface
above the blind such as a ceiling or window
reveal/recess. Use one screw in the centre for
fixing with this method.

Once the brackets have been fixed you can attach
the blind. To do this, hold the rail at a slight angle and locate the front rail lip over the edge of the spring loaded bracket lip.

Gently push the rail forwards and straighten the angle of the rail until you hear it 'click' into the rear of the bracket.

Removing the blind is simply a reversal of the fitting action. Puch the rail gently forward and twist it
downwards at the back to disengage it from the rear of the bracket. The blind rail can then be unhooked
from the front of the bracket and taken down.

The blind cord is a continuos loop. To raise the blind, simply pull down on the rear cord and to lower the blind pull down on the front cord.

Always use the cords to raise and lower blind and make sure not to untie them.